Browse our FAQs or submit your query here. Turn the ribbon-tightening knob in the direction of the arrow to remove any slack from the ribbon so it is easier to install. Switching between the cut-sheet feeder and the push tractor does not work properly The desired paper type does not load. Page Unidirectional Uni-d printing. Print Speed Draft 12 cpi. Paper Handling Single sheets do not feed properly Paper does not feed.
|Date Added:||18 September 2004|
|File Size:||42.25 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
The procedure below describes the test using single sheets, which is the easier way. Use a pointed object, such as a ball point pen, to guide the ribbon between the print head and ribbon guide. Yes Epson has a one stop link for all your service queries including self-diagnosing problems with your printer. Next, adjust the right edge guide to match the width of your paper.
Multipart forms You can use continuous or shingle-sheet carbonless multipart forms of up to four parts one original plus three Make sure the printer is turned off. Because labels are especially sensitive to temperature and humidity, use them only under normal operating conditions.
Open the printer cover to the upright position, then pull it up to remove it. One page of printing has spread to two pages.
Epson LQ-1150 User Manual
When you select On, the printer provides a one-inch Using the serial interface You need a serial cable that has a DB male connector on the printer side to use the serial interface. Assembling the Printer This section provides you with information on how to get your printer up and running.
Printers Dot Matrix Printers Brand: The position of your paper supply may be preventing it from feeding straight. M R Manual feed wait time, Removing Micro adjust, toto printed document from Multipart Make sure that your printer is selected and then click Printer, Setup, Properties, or Options.
Epson LQ User Manual – Page 1 of |
Advancing the paper to the tear-off position automatically To automatically advance your printed documents to the tear-off position, you need to turn on the prinher tear-off mode and select the appropriate page length for continuous paper in the Default Setting mode. Follow the directions on the Notice Sheet packed with the printer to remove these materials. Turn on the printer. Whenever you turn off the printer, wait at least five seconds before turning it back on; otherwise, Next, tap the side and bottom of the paper on Enter text from picture: Roll paper holder The optional roll paper holder allows you to use your printer with 8.
Take a stack of paper and fan it. Page 16 Keep the entire computer system away from potential sources of electromagnetic interference, such as loudspeakers or the base units of cordless telephones.
Right-click your printer icon, and click Document Defaults. If you cannot fix your problem using this table, go to the next section.
Turn off the printer pronter check for a paper jam, a ribbon jam or other problems. Changing the printer driver settings Your printer driver has two menus from which you can change the printer driver settings; Check that the page-length Turn the ribbon-tightening knob in the direction of the arrow to remove any slack from the ribbon so it is easier to install.
Installing the software in Windows Me, 98, 95,or NT 4.
Then slide the right sprocket unit to match the width of your paper, but do not lock it. Location All Pune Mumbai map list available at address price. Then turn on the printer. Page Continuous paper: